Scrap Car Starter Copper Puller Machine Details:

Name: Scrap Car Starter Copper Puller Recycling Machine

Machine Processing Efficiency: More than 350pcs/h

Machine Weight: 460kg

Package Weight: 500kg

Machine Size: 1.4*1.1*1.7M

Package Size: 1.5*1.2*1.8M

Machine Power: 4KW

Motor Copper Pulling Recycling Machine Main Structure:

Main structure of this copper winding wires puller machine includes hydraulic cylinder, starting switch, open close controller, foot switch, booster and rotor sleeve.

Car Starter Recycling Machine Process:

1. Copper cutting machine is used to cut off the copper wire of a section of the commutator, and dismantle of the commutator , which is the first procedure of dismantling the starter.

2. The copper winding wire is wrapped with a layer of insulation film, it needs to be heated quickly by high-frequency car starter heating machineto melt the insulation film and facilitate the copper winding wires pulling out.

3. After insulation film melts, the copper wires is pulled out by copper pulling machine from one side of motor that has not been cut to complete the dismantling process.

Electric Motor Breaking Machine Advantages:

Hydraulic clamp copper:

Six hydraulic cylinders, two opposite, clamp the copper wire, can be pulled out at one time.

Easy boost:

With hydraulic boost handle, the rotor shaft is not easy to enter the copper tube, can be boosted into, to prevent hot.

Multiplex control:

Equipment start switch, open and close controller, foot pull copper switch, independent,easy to operate.

BSGH EQUIPMENE Aftersale Service:

1. Overseas technical support available;

2. All day long 24 hours services,call me :008613772508206.